WIFI control card LAN use steps

Detailed steps for computer settings：

1. Check the name and password of the router (IP, username and password on the back of the router), as follows:

   The router's IP address is: 192.168.1.1 (for the 1 network segment control card IP address also needs to be in the 1 network segment).

2. Connect the WIFI card, load the antenna, power, open the wireless network of the computer, and find the WIFI name of the control card and click the connection.(password: 88888888)

   

3. Open FKShow,click"Setting""Display setting". （password:168）

   ChoiceControl Card，WiFi Connecting Mode"WiFi Direct"clickControl Card Detect

   

4. Test success，clickChange WiFi SettingWiFi Mode“WLAN”ChoiceWLAN SSID。

   PS:You can't find the WiFi signal you want in the list, please click the back search button
   

   inputPassowrd，Fill in the right wayIP address subnet mask gateway. (ps: reference router IP address set the control card IP address. )

   

   Fill in, click Config The lower left corner shows the success of the communication setup。

   

5. Computer connected routerConnect successfully, click“Tools”——“Control card network maintenance”

   

6. Control card search success

   
   
   

   If there are multiple control cards, please repeat the above operation PS:Remember that the IP address of the control card is not repeatable (IP conflict control card cannot be used)

   
   

7. clickRelated to the display screen,The corresponding display number

   

8. Connection completion click close, click click“Send ”——“All displays”

   

   Select the display to send, click“Start”

   

   The data is sent to complete!

Detailed steps to set up the mobile phone：

1. Open FKShow，Click on the menu bar Set→WiFi setting，Enter the setting：

   

2. click"Set"，Entering the WiFi connection interface of the mobile phone system，Choice“FK”The beginning of the WiFi。(password:88888888)

   

3. Return to the mobile phone software, click control card Detect

4. Control card detection successClick Close

5. openChange WiFi Setting，WiFi ModeWLANPattern

6. ChoiceThe name of the corresponding router，inputWifi password

7. Input correctIP Subnet mask gatewayclickConfig

8. WiFi set up successThe connection router is successful.

9. Computer connected routerConnection success，click“Tools”——“Control card network maintenance”

   

10. Control card search success

    
    
    

    If there are multiple control cards, please repeat the above operation PS:Remember that the IP address of the control card is not repeatable (IP conflict control card cannot be used)

    
    

11. clickRelated to the display screen,The corresponding display number

    

12. Connection completion click close, click click“Send ”——“All displays”

    

    Select the display to send, click“Start”

    

    The data is sent to complete!