Connecting multiple network port card operation steps through routers


Connection schematic diagram

The following example is an example of this connection diagram

Set steps to connect a LAN:

  1. Connect the control card with the network wire to the router. Check the computer IP address is automatic or fixed IP. (such as automatic acquisition, please change to a fixed IP, so as to avoid the IP conflict)

  2. When the connection is good, open it¡°FKShow¡±¡£

  3. click¡°Tools¡±¡ª¡ª¡°Control card network maintenance¡±¡£

  4. After searching for the control card£¬click¡° Stop ¡±¡£Choicecontrol card£¬click¡°IP Config¡±¡£

  5. Fill in the right way¡°IP¡±£¬¡°Subnet mask/strong>¡±£¬¡°Default gateway¡±¡£Fill in complete clicks¡°Set¡±¡£

  6. ¡°The communication setup is successful!¡±£¬Click close. Select the next click IP, repeat the operation until the IP Config address is complete.

  7. All control card IP configuration is completed.

  8. Select the control card, click¡°Binding¡±£¬Based on the requirements of the existing display screen or to create a new display screen. (a display can be associated with multiple control cards)

  9. The connection is completed, and the click is closed. Edit the program content, subtitle, text, pictures, weather, date,dial...


  10. The program editor completes, click send , all displays

  11. The data is sent to complete!