Intelligent scanning

Intelligent scan can be used if the firmware of the control card is upgraded to the latest. Step of firmware upgrading →：

U disk intelligent scan detailed step →

Network card, WiFi card, serial card intelligent scanning step

1. Get into Display Parameters，Choice“Color Type”，Choice“Gray Level”。(select the gray level to use the intelligent scan)

   

2. Choose the hook“smart scan”，click“Edit”，Choice“user defined smart scan”。

   

3. fill in“module width，madule height”，Choice“line decoding”，Select complete clicks“next”。

   

4. click“1，2”Select complete clicks based on the selection on the panel“next”。

   

5. click“1，2”Select complete clicks based on the selection on the panel“next”。

   

6. click“1，2，3，4”Select the corresponding color based on the color software displayed on the cell board, choose to complete the click“next”。

   

7. Fill in the number of rows on the board“The number of line”，Fill in complete clicks“next”。

   

8. Fill in the number of rows on the board“The number of line”，Fill in complete clicks“next”。

   

9. According to the flash unit board beads, click on the software of grid point, you can! (for example, operation error can be receded, reposition and correction)

   PS：Observe the highlights on the display module, and click on the coordinates of the coordinates with the mouse.

   

10. The drawing point is finished, click confirm.

    

11. Give you a name for your scan, and click OK after the name is finished. (please name it according to the smart scan naming specification)

    

12. Size，click“Load”，Load the screen to complete! Edit the program.

    

U disk card intelligent scanning detailed steps

1. Display Parameters，Choice“Color Type”，Choice“Gray Level”. (select the gray level to use the intelligent scan)

   

2. Choose the hook“smart scan”，click“Edit”，Choice“user defined smart scan”。

   

3. Fill in the corresponding data and fill in the U disk.

   

4. According to the flash unit board beads, click on the software of grid point, you can! (for example, operation error can be receded, reposition and correction)

   PS：Observe the highlights on the display module, and click on the coordinates of the coordinates with the mouse.

   

5. The drawing point is finished, click Conpletem.

   

6. Give you a name for your scan, and click OK after the name is finished. (please name it according to the smart scan naming specification)

   

7. Size，click“Finish”Edit the program.